Broome Engineering Home Page




aboutrmdjpg.jpg (1190 bytes)



 

Machine SpecialsBuy from UsSell to UsTrade with Ustop_nav_avail_mach[3].gif (1270 bytes)
hdr_welcome.gif (1607 bytes) Remanuf 220x58.jpg (12581 bytes)

 
Universal® Certified Remanufactured 6348A TO Radial 5+ Upgrade

If you still own an older Radial II inserter that requires quite a bit of service and Universal can no longer provide support for, there may still be good value in your asset.  Through this upgrade program from Radial II to Radial 5+ capabilities, the machine will be brought  up to a level that can and will be supported, allowing use of expense budgets vs. capital equipment expenditures.  The upgrade of your Radial includes: full remanufacture, re-installation, new software, guaranteed to perform to a radial 5+ specification (has some 8 version enhancements), and a 1 year limited warranty.

Some Benefits of upgrade program:

  • Use of maintenance budgets vs. justifying capital expenditures
  • Your Machine will be back under Universal's support again
  • Speed increased up to 10,000 CPH
  • Radial 5 Component capability (Including SIPs)
  • Improved Reliability
  • Spare parts more readily available and typically lower cost than older version parts

Upgrade List:

  • New Style Soft Tip Pusher Including Pusher Rod Reliability Upgrade
  • New Style Component Transfer Assembly (CTA)
  • New Style Sequencer Dispense Heads
  • Clip Lead Locate Upgrade Including Plastic Dispense Head Flag, Pushers, and Interposer
  • Clinch Base Upgrade Including Titanium Insert For Increased Reliability (Radial 8 Version)
  • J-11 Controller Upgrade
  • Shot Pin Upgrade to Prevent Insertion Head Damage After Power-Up
  • 10.5 or 13.0 mm Insertion Head (Radial 8 Enhancements)
  • Insertion Head Shock Absorber Upgrade (Radial 8 Enhancements) - Provides Increased Head Reliability
  • Cutter Station Upgrades to 6360E or higher level including new coupling, new flag with rubber damper, New Titanium Cutter & Anvil
  • Software Selectable Inch or Metric Rather Than Mechanical Changeover
  • Card and Transistor Eliminated From Chain Drive Amp - New Copley Amp Used
  • Radial 5 Style ERV Head Assembly
  • Four Clinch Selections - 3 "N" Types & "T" Type (Radial 8 Style)
  • New Style Continuity Cables on Clinch for Increased Reliability
  • 10,000 CPH Cycle Rate

   R6358 Front End Photo     R6358 Head and CTA Photo